Topcom Skylanr@cer 500 - Manual (Page 7)

When the connection has been successfully established, the left side of the status bar shows the mes-
sage “Get Configuration Done” while the right side appears the IP Address of the connected Access
Point. At the same time, the Access Point Settings window pops up within the utility window.
From now on, you can start to customise the Access Point settings as described in next section.
Configuring the Access Point
Access Point Setting
Access Point settings window always opens automatically when you connect to the target Access
Point. This window allows you to make the basic settings for proper operation. Enter the required
values for the parameters below:
Access Point Name: The name used for identifying the Access Point.
ESSID (Extended Service Set Identity): The name used for identifying the WLAN.
Channel::The radio frequency used for communication. Select a channel out of the available channels
or used the default channel.
Dynamic/Static IP Settings: Select whether to use Dynamic IP or Static IP as required by your netw-
ork requirements. If you want to enable the Dynamic IP Address (DHCP Client Enable) option,
select whether to use the DHCP Server in Ethernet or Wireless, which is the interface that determi-
nes the DHCP server.
Note: After setup, click OK and then select File > Download Changes to save changes. When “Do you want to
Download Configuration?” message appears, click Yes. When download is finished, you’ll see “Download configura-
tion done” message on the status bar.
SkyLanR @ cer 500
7
ENGLISH