TMIO PS302SS00 - Manual (Page 15)

From the Main Screen
• Select
My Oven drop down
• Select Network Settings
• Toggle the Use DHCP button to “on”
• Select OK to save settings and return to the Main Screen, or Cancel
to discard the settings and return to the Main Screen
From the Main Screen
• Select
My Oven drop down
• Select Remote Access
• Select Phone # and enter the 10 digit phone number you will most
likely be calling from to access the oven. Caller ID will recognize
your phone number.
Note: When calling from a different phone number, the Caller ID will
not be recognized automatically, and you will be prompted to enter the
phone number you entered here as part of the log in process. To log
in via the www.tmio.com web page, enter this phone number. (See
Remote Control of Your Oven section below)
• Select
PIN # and enter a 4 digit numeric number only (changes to PIN
can only be done at oven interface)
• Toggle Remote Access button to “on”
• Select OK to save settings and return to the Main Screen, or Cancel
to discard the settings and return to the Main Screen
Remote Access
You must enable Remote Access to access your oven from a web browser or via a phone. Enable Remote
Access by entering a 10 digit phone number and 4 digit PIN number, and set the Remote Access to “on”.
This phone number and PIN are required at log in.
MY OVEN
Network Settings
Network Settings sets up your oven for Internet connectivity (Dial up is not supported). Most home networks
use DHCP to assign IP addresses. If your home network uses fixed IP addresses, then set DHCP to “off”
and enter the address manually. Additional information is available in our Frequently Asked Questions (FAQ)
section on our website www.tmio.com.
12