The Eltron Company PRIVILEGE P600 - Manual (Page 37)

Card Gate
Adjustment and
Media Loading
Step 2
With a single card end just under the gate, turn
the adjustment knob counterclockwise to lower
the gate to the point the gate just contacts the
card. Note that any further lowering pivots the
other end of the card off of the right feed roller.
Turn the knob clockwise a quarter turn to add
some space between the gate and the card.
Card Gate
Adjustment and
Media Loading
Step 3
Place a second card on top of the first. Without
bending or deforming the cards, try to slide
both cards through the gate, If only the lower
card fits, the adjustment should suffice. If both
cards fit under the gate, either lower the gate
slightly or repeat the previous steps.
Card Gate
Adjustment and
Media Loading
Step 4
Add cards of the same thickness to the Card
Feed hopper sufficient for the printing needs
and place the Card Weight on top of the stack.
During the first few print cycles, watch for card
jams or feed failures. Alternately, send a Card
Feed command to check for proper feeds, as
follows:
From the Windows Driver (See Appendix C),
type:
ME↵
where:
↵ = Enter
From WindCard (See WindCard manual), Se-
lect Printer Tools. In the Printer Tools dialog
box Enter:
ME↵
980179-001 Rev. A
29
Operation