The Eltron Company PRIVILEGE P600 - Manual (Page 49)

The following command shuttles a Cleaning
Card from the Input Hopper to the Card
Catcher:
ME↵
For best results, shuttle a card five or more
times.
Cleaning the
Card-Feed Roller
Card Feed Rollers that fail to grip the cards can
impede the even delivery of cards to the trans-
port rollers. To clean the Card-Feed Rollers,
proceed as follows:
Cleaning the
Feeder Rollers
Step 1
Remove any cards from the Card Hopper.
Cleaning the
Feeder Rollers
Step 2
Clean the rollers using a Swab or Cleaning
Pen. To gain access to initially unexposed ar-
eas, cycle the roller by applying the printer
power while holding the Panel Button on for
three (3) seconds (see Test Card sequence in
preceding description) Let the roller air dry for
two (2) or more minutes.
980179-001 Rev. A
41
Operation
Figure 2-15
Card-Feed Rollers Card-Feed
Rollers
Card-Feed
Rollers