The Eltron Company PRIVILEGE P600 - Manual (Page 51)

Cleaning the
Cleaning Rollers
Step 3
Use a swab or cleaning pen on the Lower
Cleaning Rollers. Cycle the rollers by applying
the printer power while holding the Panel But-
ton on for three (3) seconds to expose initially
unexposed areas. This is the Test Card se-
quence described in Controls and Indicators,
Section 2.
Cleaning the
Cleaning Rollers
Step 4
Reinstall the Upper Cleaning Roller. First slide
the shaft pin into the hole in the chassis oppo-
site the Spring Tab.
DO NOT touch the roller surface that contacts
the media.
Snap the opposite shaft pin of the roller into the
hole on the Spring Tab.
Without touching the body of the roller, make
sure the roller locks in place. To avoid contami-
nation, always hold the roller by the metal
ends.
980179-001 Rev. A
43
Operation
Figure 2-17
Lower Cleaning
Roller