Tyco Electronics LD9000 Series - Manual (Page 127)

USB HID Keyboard Emulation Swipe Reader
22
PRE_TK_CHAR PROPERTY
Property ID: 13 (0D hex)
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0
Description: This character is sent prior to the data for each track. If the value is 0 no
character is sent. If the value is in the range 1 – 127 then the equivalent
ASCII character will be sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.
POST_TK_CHAR PROPERTY
Property ID: 14 (0E hex)
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0
Description: This character is sent after the data for each track. If the value is 0 no
character is sent. If the value is in the range 1 – 127 then the equivalent
ASCII character be sent.
This property is stored in non-volatile EEPROM memory so it will not change when the unit is
power cycled. When this property is changed, the unit must be power cycled to have these
changes take effect. If a value other than the default value is desired, it can be set by the factory
upon request.
ASCII_TO_KEYPRESS_CONVERSION_TYPE PROPERTY
Property ID: 15 (0F hex)
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0 (keymap)
Description: The value is a byte that represents the devices ASCII to keypress conversion
type. The value can be set to 0 for keymap (United states keyboard
emulation) or to 1 for ALT ASCII code (international keyboard emulation).
When the value is set to 0 (keymap), data will be transmited to the host