Toshiba 3006GAL - Manual (Page 157)

Toshiba Corporation Digital Media Network Company
Page 157 of 157
© 2005, Copyright TOSHIBA Corporation All Rights Reserved
11.6 Other timings
See HOST INTERFACE section for timings which are not shown here.
Table 11.6-1 Other timings.
Function and Intervals Timeout
• POWER ON TIMINGS
From power on to BSY=1 400 ns maximum
From Power on to BSY=0, DRDY=1 31 s maximum
• SOFT RESET TIMINGS
From soft reset assertion (SRST=1) to BSY=1 400 ns maximum
From soft reset negation (SRST=0) to drive ready (BSY=0, DRDY=1) 10 sec maximum
• HARD RESET TIMINGS
From hard reset assertion to BSY=1 400 ns maximum
From hard reset negation to drive ready (BSY=0, DRDY=1) 31 sec maximum
• DATA IN COMMANDS
From writing to command register to BSY=1 400 ns maximum
From BSY=1 to BSY=0, DRQ=1, INTRQ set (When the drive is in idle mode) 20 sec maximum
From BSY=1 to BSY=0, DRQ=1, INTRQ set (When the drive is in standby mode) 35 sec maximum
Drive Busy during data transfer 5
µs
minimum
• DATA OUT COMMANDS
From writing to command register to BSY=1 400 ns maximum
From BSY=1 to BSY=0, DRQ=1 700
µs(*1)
maximum
Drive Busy during data transfer 5
µs
minimum
From BSY=1 to INTRQ set (When the drive is in idle mode) 10 sec maximum
From BSY=1 to INTRQ set (When the drive is in standby mode) 25 sec maximum
• NON-DATA COMMANDS
From writing to command register to BSY=1 400 ns maximum
From BSY=1 to INTRQ set (When the drive is in standby mode) 17 sec maximum
• DMA DATA TRANSFER COMMANDS
From writing to command register to BSY=1 400 ns maximum
(*1) When the following commands are issued by the host as First Command after hardware reset, the command’s
time-out value of the field is 10 seconds.
Security Diable Password
Security Erase Unit
Security Set Password
Security Unlock