Toshiba 3006GAL User Manual

Page 93

Advertising
background image

Toshiba Corporation Digital Media Network Company

Page 93 of 157

© 2005, Copyright TOSHIBA Corporation All Rights Reserved

10.8.31 SET MAX (F9h)

Individual SET MAX commands are identified by the value placed in the Features register. Table 10.8-6 shows
these Features register values. But regardless of Feature register value, the case this command is immediately
proceded by a Read Native Max ADRESS comamnd, it is interpreted as a Set Max ADDRESS command.

Table 10.8-6 SET MAX Features register values

Value Command

00h Obsolete
01h

SET MAX SET PASSWORD

02h

SET MAX LOCK

03h

SET MAX UNLOCK

04h

SET MAX FREEZE LOCK

05h-FFh Reserved


10.8.31.1 Set Max Address

COMMAND CODE

1 1 1 1 1 0 0 1

REGISTER

REGISTER SETTING

NORMAL COMPLETION

DR

DRIVE No.

no change

CY

Max. cylinder number

no change

HD

Max. head number

no change

SN

Max. sector number

no change

SC 00

H

/ 01

H

(BITO: reserved bit)

no change

FT

no

change

LBA

Max. LBA

no change

This command specifies the the maximum address in a range of actual drive capacity. The values set in CY,
HD, SN registers indicate the maximum address that can be accessed. In CHS mode, the value of Read Native
Max Address command should be set in HD, SN register. Otherwise, the value shall be ignored and the value of
Read Max Address command will be used. If an LBA bit (DRV / HD register bit 6) is set, the value in LBA mode
shall be set. If the address exceeding the set value is accessed , “ ABORT ERROR “ error will be reported. This
set value affects the values of WORD 1, 54, 57, 58, 60, 61, 100-103 of IDENTIFY DEVICE command.

This command shall be immediately preceded by Read Native Max Address command. Otherwise, it will be
terminated with “ ABORT ERROR ” .

If this command is issued twice with a volatile bit set to 1 after power-up or hardware reset, “ID Not Found
error” will be reported.

If a host protected area has been established by a SET MAX ADDRESS EXT command, this command will be
terminated with “ ABORT ERROR ” .

Volatile bit ( SC register bit 0 ) :
If this command is issued with a volatile bit set to 1, the set value of this command is valid after power-up or
hardware reset.
If this command is issued with a volatile bit cleared to 0, the set value of this command shall be cleared after
hard reset or power-on and the maximam value shall be the last value with a volatile bit set to 1.

Advertising
This manual is related to the following products: