TANDBERG F1 D13642.01 - Manual (Page 55)

3 General Use
51
3.12.9 More about MultiSite (embedded MCU)
(Optional Feature)
Calling in to a MultiSite
Any system can be part of a MultiSite conference by calling in to a MultiSite. The dial-in
numbers to the MultiSite depends of the network that is used.
To dial in to the MultiSite on IP:

Dial the IP Number or the IP Address of the system. All sites can dial the same
number.
To dial in to the MultiSite on ISDN-PRI:

Dial the ISDN number of the system. All sites can dial the same number.
To dial in to the MultiSite on ISDN-BRI:

The MultiSite has specific numbers for each call that participates in the conference.
To find the dial-in numbers for the MultiSite, choose Information from the main menu
and open System Information from the bottom menu line.

Site 2 must dial MultiSite Number 2.

Site 3 must dial MultiSite Number 3.

Site 4 must dial MultiSite Number 4.

And so forth
Receiving calls to a MultiSite
When the MultiSite receives incoming calls you can accept or reject it. Pressing the green key
is equivalent to pressing Accept. Pressing the red key is equivalent to pressing Reject.
End a MultiSite Call
Ending a MultiSite Call is not very different from ending a normal point-to-point call. Use the
red key on the remote control or End Call from the main menu. The end call menu lists all the
calls that participate in the conference. To end a single call, select the call, press OK or the
red key on the remote control. To end all calls, press the End All Calls button in the menu.
Duo Video in MultiSite calls
In a MultiSite call, the MultiSite can transmit the Duo Video and/or H.329 to the other
participants that support Duo Video and/or H.329. This means that any participant can send
Duo Video and the MultiSite will transmit it to the other participants. The participants that do
not support Duo Video or H.329 will only receive Main Video.
Mix ISDN/LAN
A conference can consist of any combination of ISDN/IP sites.