Telos NX12 - Manual (Page 130)

120 | appendix 3
Give us:
Two SPID numbers, depending upon number of active B channels
♦
Two Directory Numbers
♦
PROTOCOL: AT&T Point-to-Point (Custom)
Software version 5E4.2 and above.
CO Values
Line Type (DSL class): Custom Point-to-Point (PTP)
♦
B1 Service: On Demand (DMD)
♦
B2 Service: On Demand (DMD)
♦
Maximum B Channels (MaxChan): 2
♦
CSV Channels: Any
♦
Number of CSV calls: 2
♦
CSD Channels: Any (CSV is required; CSD may be omitted if requested by user)
♦
Number of CSD calls: 2
♦
Terminal Type: A
♦
Number Display: No
♦
Call Appearance Pref:Idle
♦
10XXXXX Long Distance Prefix: Yes
♦
Turn off features such as; packet mode data, multiple call appearances, Electronic Key Tele-
phone Sets (EKTS), shared directory numbers, accept special type of number, intercom groups,
network resource selector (modem pools), message waiting, hunting, interLata competition, etc.
Note for AT&T/Lucent 5ESS on loop extended lines: REX test must be disabled for this line
using one of the following: ASDFI266 (Prohibit REX on BRI lines per office) or ASDFI267
(Prohibit REX on BRI lines per line)
Give us:
One Directory Number
♦