Telos NX12 - Manual (Page 95)

TeChnICal daTa & TrouBleshooTIng | 85
Cause No. 38 - Net out of order
This cause indicates that the network is not functioning correctly and that the condition is likely
to last a relatively long period of time e.g. immediately re-attempting the call is not likely to be
successful.
Cause No. 39 – Permanent frame mode connection is out-of-service [Q.850 only]
This cause indicates a calls has been preempted due to the circuit being reserved for reuse.
Cause No. 40 – Permanent frame mode connection is operational [Q.850 only]
This cause indicates a calls has been preempted due to the circuit being reserved for reuse.
Cause No. 41 – Net problem, redial (Temporary Failure)
This cause indicates that the network is not functioning correctly and that the condition is not
likely to last a long period of time; e.g. the user may wish to try another call attempt almost
immediately. May also indicate a data link layer malfunction locally or at the remote network
interface or that a call was cleared due to protocol error(s) at the remote network interface.
Cause No. 42 – Net busy, redial (Switching Equipment Congestion)
This cause indicates that the switching equipment generating this cause is experiencing a period
of high traffic.
Cause No. 43 – Access/user information discarded
This cause indicates that the network unable to deliver user information (i.e user-to-user
information, low level compatibility or sub-address, etc) to the remote users as requested.
Cause No. 44 – No channel available (Requested circuit/channel not available)
This cause is returned when the circuit or channel indicated by the requesting entity cannot be
provided by the other side of the interface.
Cause No. 46 – Precedence call blocked [Q.850 only]
This cause is used to indicate that there are no pre-emptable circuits or that the called user is
busy with a call of equal or higher pre-emptable level.
Cause No. 47 – Resource unavailable/New Destination
This cause is used to report a resource unavailable event only when no other cause in the
resource unavailable class applies.
or
This cause is used to indicate that the original destination is unavailable and to invoke redirec-
tion to a new destination.
Cause No. 49 – QOS unacceptable
This cause is returned when the Quality of Service is unacceptable.
CLASS 1.3 (service or option not available)
Cause No. 50 – Requested facility not subscribed
The cause is used to report that the user cannot use this feature because s/he has not subscribed
to it.
Cause No. 51 – Bearer capability incompatible with service request
This cause indicates a user request for action was rejected because the action was incompatible
with the capability of the call.
Cause No. 52 – Outgoing calls barred
This cause indicates that because of call screening provided by the network, the calling user is
not permitted to make a call.