Telos NX12 - Manual (Page 72)

62 | section 5
Reboot System?
This menu has two options:
No
♦
– Goes back to the Reboot System sub-menu.
Yes
♦
– Causes the system to reboot. (All callers will be lost.)
This command is intended to save you a trip to the back of the rack. This reboot is equivalent to
removing power and then restoring it.
Firmware Update (Web Only)
See Section 5.9.
5.7 Show Modes
Recall that the options for Show Modes are:
One Show
♦
4 Column
♦
2 Show Split
♦
2 Show Shared
♦
2 Show Custom
♦
Note: You must reboot the system after configuring this setting. Be sure to attach the phone
lines before rebooting.
Single-studio Modes
One Show (default)
Four hybrids are used to improve conferencing quality, but they are summed and mix-minused
internally to appear as if they were two. (Or one, depending upon Mix Minus mode.) Each
Desktop Director column can use up to two hybrids, with the first call on the left column
connecting to Hybrid A, the second to Hybrid B, the third to Hybrid A, the fourth to Hybrid
B, etc.
Only POH input 1 is used.
4 Column
This supports Desktop Directors with the add-on module to make four line-select columns.
Each column is connected to one of the four Nx12 hybrids, the leftmost to A, the next to B,
etc. The four inputs and outputs are only accessible via AES and Livewire, and 4 Column mode
cannot be used with the analog I/O option.
This also supports a Euro-style operation method where each of four Telco lines has its own
hybrid and fader. As this is written, this mode is only possible with Euro-phone modules
installed in an Axia Element mixing console.
Only POH input 1 is used.