Telos NX12 - Manual (Page 59)

deTaIled ConfIguraTIon & referenCe | 49
send level. However, doing so can reduce effective hybrid performance and increase leakage.
Conversely, lowering this setting can reduce leakage.
Call Ducking
This control adjusts the amount of ducking that occurs to the received telephone audio when
send-to-caller audio is present. A value of Full Duplex means that the telephone audio is never
ducked or attenuated, while Half Duplex applies maximum attenuation when send audio is
present. Intermediate settings range from -1 to -15dB. Section 5.11 has more information on
this function. Ducking is desirable for a variety of reasons:
Allows the announcer to ‘override’ the caller by causing the received caller audio to be
♦
attenuated (ducked) when the announcer speaks. This is often desired for aesthetic effect
and allows the announcer to remain in control of the conversation.
Helps to have open loudspeaker monitoring of callers without feedback.
♦
Dynamically improves effective trans-hybrid loss to reduce leakage, when necessary.
♦
There is also a ducking of the announcer audio to the caller. This is only a few dB unless Feed-
back Reduction is enabled, as described below. This send ducker has a fixed value.
Receive AGC
The receive Automatic Gain Control serves to improve level consistency of caller audio. Nomi-
nal levels of the telephone network vary as much as 30dB from call to call. In the past decade
our experience has been that loud calls have become just as much a problem as low level callers.
Therefore we have changed the AGC to act as a platform leveler. The Nx12 uses a dB-linear
approach to AGC with a feed-forward topology, which provides a consistent sound regardless of
the drive level. This “smart compressor” normalizes levels while retaining the natural dynamics of
the caller’s voice.
This selection controls the “aggressiveness” of the AGC process, taking values from OFF, 1/4,
1/2, 3/4 to FULL. We suggest you start with the default value, FULL
Aggressive AGC is more noticeable, but is also more effective at maintaining consistent levels.
Adjustment of this setting simultaneously changes as number of parameters within the AGC
function, such as attack & release times, thresholds, and compression ratio.
An important feature of the Nx12’s AGC is that it is cross-coupled to other sections of the
hybrid so that it can reliably distinguish between the real caller audio and residual hybrid leak-
age. This allows a lot of gain on low level callers while preserving excellent hybrid performance.
Noise Gate
Enables or disables a noise gate applied to the caller audio. This is a “downward expander” that
has the effect of reducing the noise on the caller audio when it falls below a threshold. On some
very low-level calls, this attenuation may be inappropriate because you may be able to hear the
caller fade away when the level falls below the threshold. It has three settings as follows:
Off
♦
– Disables the noise gate
Normal
♦
– A slow setting, with moderate noise attenuation
Aggressive
♦
– A faster setting with deeper attenuation, for lines where noise is noticeable
during normal conversation.