Tesla TI2000GPU-24 - Manual (Page 20)

that cooling fan is functioning.
4-2
CAUTION
REMEMBER,when the AC line cord is plugged in, the unit must be placed
in the horizontal position to allow the cooling fan to operate prop-
erly!
Unit may overheat if cooling fan fails. Do not operate if cooling
fan fails.(More than one green bar present on bar graph)
3. CHECK DC POWER CABLE/CONNECTORS FOR DAMAGE - Check cable for
cuts, chafing or evidence of being crushed. Check connectors for
cracks, cuts, distortions, excessive wear, broken/loose fasteners or
loose cable attachment.
4-6. 24 VDC GROUND POWER (NO 120 OR 240 VAC POWER SUPPLY) ENGINE
STARTING OR DC SYSTEM POWER
1. TRANSPORT UNIT - The Turbo Start 2000 is easily transported using
the wheels that are incorparated into the unit. The AXEL EXTENTION
kit (included with the unit) ensures that the Turbo Start 2000 is
stable. The unit is engineered to be pushed rather than pulled.
2. CONNECT DC POWER CABLE TO UNIT - Ensure power cable connector is
fully seated into unit’s connector. Set the unit down horizontally
ensuring vent ports are un-blocked.
3. CONNECT DC POWER CABLE TO AIRCRAFT - Ensure ground power
cable connector is fully seated into aircraft ground power recep-
tacle. DC bus power should come on and aircraft volt meter should
indicate 24 VDC to 23.5 VDC (23 VDC minimum).
4. ENGINE STARTING - Check power cable for security and correct
installation prior to engine start. Follow ground power engine