Tally Genicom Matrix Printer - Manual (Page 13)

7265 Programmer’s Manual
9
Copyright © 2004 TallyGenicom Chapter 2 ANSI
Printer Control
Commands Description
SO SHIFT OUT
You can strap the printer to start either barcode (page 37) or oversized (page 64)
mode, whichever is enabled, on receipt of SO. The ISU status of SO/SI control is
disabled. You can enable SO/SI control from Software Options on the printed menu,
or from the host via the Straps and Options control sequence. See page 14.
Dec 14
Hex 0E
SI SHIFT IN
If the printer is strapped to turn on barcode or oversized on receipt of SO, then SI
turns barcode (page 37) or oversized (page 64) mode off.
Dec 15
Hex 0F
ESC ESCAPE
Introduces an escape sequence. The printer evaluates characters following the ESC
character to determine if the sequence is valid. If the sequence is valid, then the
printer responds to the command. If the sequence is not valid, then the printer aborts
the process, discarding at least the first character following ESC.
Dec 27
Hex 1B
ESC P
(DCS) DEVICE CONTROL STRING
The control function introducer for the device control string structure, which is used to
frame graphics.
Dec 144
Hex 90
ESC [
(CSI) The CSI character is the control function introducer for the ANSI control sequence.
Control sequences are multi-character control functions that accept parameters.
Dec 155
Hex 9B
ESC \
(ST) STRING TERMINATOR
Terminates the DCS and the OSC sequence.
Dec 156
Hex 9C
ESC ]
(OSC) The OSC character is the introducer for straps and options.
Dec 157 Hex 9D
BEL BEEPER
Dec 7 Hex 07