P10 - horizontal resolution, P11 - check character enable, P12 - human readable font – Tally Genicom Matrix Printer User Manual
Page 45: P13 - height in 1/24-inch increments
7265 Programmer’s Manual
41
Copyright © 2004 TallyGenicom Chapter 3 ANSI Bar Codes
p10 - Horizontal Resolution
A value of 0 is 60 dots per inch, while a value of 1 is 1/120 dots per inch. The default depends on
the style in force. EAN and UPC styles default to 1. All other styles default to 0.
Note: This parameter affects bar codes printed at 0
o
or 180
o
rotation only. If you select the higher
resolution, then bar codes are darker and are printed at a somewhat slower speed.
p11 - Check Character Enable
N / A
p12 - Human Readable Font
N / A
p13 - Height in 1/24-inch Increments
Normally, bar code height is specified in 1/12-inch increments by p2. Only specify p13 if your job
requires the associated higher resolution of bar code height. A non-zero value of p13 supplants
the value of p2.
Caution: In some versions of the printer, a non-zero value of p13 supplants all subsequent
values of p2 until you ISU that printer. To be on the safe side, if you do not plan to use p13, then
set p13 to 0. NOTE: Bar code height is limited to 10 inches.