Tally Genicom Matrix Printer - Manual (Page 364)

The default parameter values are the following:
Unsecured mode (see section "Secured/Unsecured mode")
HRI OFF, Normal Print, Double Pass (F = SP)
Barcode Type 2/5 matrix (a = "A")
Barcode height 1/6 inch (n = "1")
Narrow bar (x = "0")
Narrow space (y = "0")
Ratio of wide to narrow 2 to 1 (z = "0")
When only parts of the header are to be changed, copy the header up to the parameter
which must be changed, and then close the header with the end-of-header character. If a
header error was detected the total previous features are still active.
The "Barcode brackets" (hex.14, dec.20), initiate and terminate the printing of the bar-
codes.
If the printer is switched OFFLINE, all defined barcodes are printed out completely. Plea-
se not that the barcode remains resident in the background and can be activated again
by the barcode bracket. Text justification and centering are both permitted. With activated
barcodes these function are not carried out, since they lead to conflicts with the barcodes.
Transparent
Barcode /
LCP commands Following control codes in Barcode strings can be substituted by the appropriate MTPL
sequences (see also section "Special Feature" on page 5):
Control Code ANSI Sequence (CSI = Hex 9B or ESC[ )
SUB CSI 26 Space s
EM CSI 25 Space s
DC4 CSI 20 Space s
DLE CSI 16 Space s
SI CSI 15 Space s
MTPL sequences with not matching parameters will be ignored.
This sequences may only be used with activated BARCODE.
Barcode Printing 9