Operator safety summary – TANDBERG Maestro MXP User Manual
Page 7
User Manual
vii
Operator Safety Summary
Operator Safety Summary
For your protection please read these safety instructions completely before you connect the
equipment to the power source. Carefully observe all warnings, precautions and instructions both
on the apparatus and in these operating instructions.
Keep this manual for future reference.
Water and Moisture
Do not operate the apparatus under or near water - for example near a bathtub, kitchen
sink, or laundry tub, in a wet basement, near a swimming pool or in other areas with high
humidity.
Never install jacks for communication cables in wet locations unless the jack is
specifically designed for wet locations.
Do not touch the product with wet hands.
Cleaning
Unplug the apparatus from communication lines, mains power-outlet or any power source
before cleaning or polishing. Do not use liquid cleaners or aerosol cleaners. Use a lint-
free cloth lightly moistened with water for cleaning the exterior of the apparatus.
Unplug the apparatus from communication lines before cleaning or polishing. Do not use
liquid cleaners or aerosol cleaners. Use a lint-free cloth lightly moistened with water for
cleaning the exterior of the apparatus.
Ventilation
Do not block any of the ventilation openings of the apparatus. Never cover the slots and
openings with a cloth or other material. Never install the apparatus near heat sources
such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat.
Do not place the product in direct sunlight or close to a surface directly heated by the
sun.
Lightning
Never use this apparatus, or connect/disconnect communication cables or power cables
during lightning storms.
Dust
Do not operate the apparatus in areas with high concentration of dust
Vibration
Do not operate the apparatus in areas with vibration or place it on an unstable surface.
Power connection and Hazardous voltage
The product may have hazardous voltage inside. Never attempt to open this product, or
any peripherals connected to the product, where this action requires a tool.
This product should always be powered from an earthed power outlet.
Never connect attached power supply cord to other products.