Toshiba W-808 - Manual (Page 26)

26
Index Search Function
The VCR can find a point where a registered index signal is on a
tape and play back for about 5 seconds. You can easily locate
the desired program by inputting the index signal.
Registering index signals
Each time a recording starts, an index signal is automatically registered.
To register it somewhere else, press
INDEX f during recording.
Note
A certain interval is required between the index signals: more than 1 minute in
the SP tape speed and more than 3 minutes in the SLP tape speed.
Index search
1
Load a cassette with the index signals registered.
2
Press INDEX in the stop or playback mode.
g INDEX: To search in the reverse
direction.
INDEX
f
: To search in the forward
direction.
The VCR fast-forwards or rewinds the
tape. When an index signal is found, the
VCR plays back the tape for about 5
seconds, and then resumes fast-
forwarding or rewinding. This is repeated
each time at an index signal.
3
Press PLAY/x2 when the desired program is found.
Normal playback starts.
Notes
• At the very beginning of the tape, the index search may not work properly.
• If you registered the index signals on a tape recorded on another VCR, the
recording may be blurred at the index point and the index search may not
work properly.
2 1 1 2
Playback
for 5 sec. Playback
for 5 sec. Playback
for 5 sec. Playback
for 5 sec.
Index search
0 0 0 0 0
H M S
I NDEX MARK
A.SELECT REMAIN
COUNTER
COUNT
RESET
POWER CH DOWN CH UP
DNR
2 1 3
5 4 6
8 7 9
0 100
ENTER
STOP
VCR Plus+
REW FF
PLAY/x2
3
2
Useful Functions in Tape Operation (continued)