Toshiba W-808 - Manual (Page 43)

43
RECORDING
VCR display
OFF: if your DSS ® satellite receiver is NON
remote-controllable.
• Satellite channels will be selected by the own
channel selector of the DSS ® satellite receiver.
The VCR channel should be set to the output
channel of the DSS
® satellite receiver.
→
Go to step 8.
7
Select “BRAND TYPE” using STOP , and enter a brand code
of your DSS ® satellite receiver using number buttons . Refer
to the table on the next page.
Example: For a TOSHIBA DSS ® satellite receiver, identified by
number 99.
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
®
satellite receiver on the VCR so that it can receive the infrared signal.
8 Press PROG. to exit.
Notes
• If your satellite channel does not change to 200 in step
7 , the DSS ® satetllite
receiver will not be able to change channels in the timer recording. In this
case, set “CONTROL” to “OFF” in step
6 .
• The VCR Plus+ C 3 ® system recording is not available on satellite channels.
• The DSS ® satellite receiver control is not compatible with the cable box
control.
PROG
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
C . BOX S S D
H C 3
9 9
O n
. O n
n O FF O CO n T O R L
BRA n T D YPE
PROG
USE
OUT UT CH
P
E D: n
SET UP PRESET PROGRAM
C . BOX S S D
H C 3
O n
n O FF O CO n T O R L
Buttons to control a remote-
controllable DSS
® satellite receiver
Once you complete the set-up for a remote
controllable DSS
® satellite receiver, your DSS ®
satellite receiver can be controlled by the
following buttons on the remote control of the
VCR.
•
POWER (CABLE BOX)
To turn the DSS
® satellite receiver on or off.
• CH UP/ CH DOWN (CABLE BOX)
To select satellite channels in the upper or
lower direction. (not applicable to some brands
of DSS
® satellite receiver.)
• Number buttons (0 – 9)
To select desired channels to record.
Table of DSS ® satellite receiver brand
codes
TOSHIBA 99
RCA 98
SONY 97
Brand name of your
DSS
® satellite receiver
Brand code