Tektronix MTG100 - Manual (Page 30)

Getting Started
MTG100 & MTG300 MPEG Generator User Manual
1Ć9
The MPEG generator automatically runs diagnostics when the instrument is
powered on using the ON/STBY switch. These diagnostics check that the
instrument is performing within its defined operating characteristics. If all of the
diagnostic checks are completed without any errors, the instrument displays the
menu bar and status bar.
NOTE. If the instrument chassis temperature is outside the specified operating
range, an error will occur during the power-up diagnostics. If this happens,
power off the instrument, wait until the chassis temperature is within normal
operating range, and then power on the instrument again.
If a diagnostic error is displayed during instrument start up, contact your local
Tektronix Field Office or representative.
Repackaging for Shipment
When you ship this instrument, use the original packaging material if possible.
If the original packaging is unfit for use or is not available, repackage the
instrument using the following procedure:
1. Obtain a corrugated cardboard shipping carton having inside dimensions at
least six inches greater than the instrument dimensions and having a carton
test strength of at least 125 kg (275 pounds).
2. If the instrument is being shipped to a Tektronix Service Center for repair or
calibration, attach a tag to the instrument showing the following information:
H The owner of the instrument (with address).
H The name of a person at your firm who may be contacted if additional
information is needed.
H The complete instrument type and serial number.
H A description of the service required.
3. Wrap the instrument with polyethylene sheeting or equivalent to protect the
outside finish and prevent entry of packing materials into the instrument.
4. Cushion the instrument on all sides by tightly packing dunnage or urethane
foam between the carton and the instrument, allowing for three inches
(7.62 cm) of padding on each side (including top and bottom).
5. Seal the carton with shipping tape or with an industrial stapler.
6. Mark the address of the Tektronix Service Center and your return address on
the carton in one or more prominent locations.
StartĆUp Diagnostics
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com