Tannoy ACTIVE STUDIO MONITORS - Manual (Page 18)

5.1 Analog Set-up
The diagram shows how to connect a 5.1 analog set-up.
The Centre monitor is set as the System Controller by leaving
out the TC Link button on the rear panel.
The Centre monitor receives audio for both centre (input 1) &
LFE channels (input 2) via the analog input connectors. The LFE
subwoofer is fed via the RJ-45 connection from the left monitor.
RJ45 Network connections from the Centre monitor to the Left &
Right monitors are required.
The Left Monitor receives audio for both Left (input 1) & LS
channels (input 2) via the analog input connectors. The LS monitor
is fed via the RJ-45 connection from the Left monitor.
The Right Monitor receives audio for both Right (input 1) & RS
channels (input 2) via the analog input connectors. The RS monitor
is fed via the RJ-45 connection from the Right monitor.
When no Bass management is selected, only the LFE signal will be
sent to the subwoofer.
When Bass management is selected, low frequency content from
the 5 main channels is extracted and sent to the subwoofer where
it is summed with the LFE channel
The iDP
™ Remote, iDP SOFT ™ or PC-iP ™ can be connected to any spare
TC Link “out” connection.
! REMEMBER – To set a master monitor as the system controller
the TC Link button on the rear panel MUST be in the out position.
5.1 Digital Set-up
The diagram shows how to connect a 5.1 digital set-up.
All Master monitors require installed digital I/O cards.
AES signal is fed to input 2 of these cards.
The Centre monitor is set as the System Controller by leaving out
the TC Link button on the rear panel.
The Centre monitor receives audio for both centre & LFE channels
via the AES input connector (input 2). The LFE subwoofer is fed via
the RJ-45 connection from the left monitor.
RJ45 Network connections from the Centre monitor to the Left &
Right monitors are required.
The Left Monitor receives audio for both Left & LS channels via the
AES input connector (input 2). The LS monitor is fed via the RJ-45
connection from the Left monitor.
The Right Monitor receives audio for both Right & RS channels via
the AES input connector (input 2). The RS monitor is fed via the
RJ-45 connection from the Left monitor.
When no Bass management is selected, only the LFE signal will be
sent to the subwoofer.
When Bass management is selected, low frequency content from the
5 main channels is extracted and sent to the subwoofer where it is summed with the LFE channel
The iDP
™ Remote, iDP SOFT ™ or PC-iP ™ can be connected to any spare TC Link “out” connection.
! REMEMBER – To set a master monitor as the system controller the
TC Link button on the rear panel MUST be in the out position.
18
A C T I V E S T U D I O M O N I T O R S