Tannoy ACTIVE STUDIO MONITORS - Manual (Page 35)

35
iDP SOFT
™
(cont.)
This is the Main screen from where all other iDP SOFT ™ screens are accessed.
When The (((•))) network icon (upper left corner)
Is steady - The computer running the iDP SOFT
™ is not correctly connected to Precision iDP ™ monitors. Check connections,
cables and refer to the setup-illustrations on pages 16-24 in this manual.
Is blinking - The computer is correctly connected to your Precision iDP
™ system.
The ((( ))) icon is also used to access the Network screen.
Press ((( ))) to access.
VOLUME Control
Use the mouse on the VOLUME control on the middle of the display to adjust the volume
REF LEV. keys
The three keys below the volume control allow access to the 3 user-defined Reference level settings.
To change these Ref. Levels:
Set the volume control to the desired position.
Hold cursor above Ref. Level key and select “Store” from the pop-up icons appearing.
Monitor and Sub icons
Appropriate icons as illustrated above will indicate Precision iDP™ monitors and subs. Press to access specific parameters
for the monitors.
This symbol in the Main screen indicates that the selected setup expects a monitor at a certain position
but no monitor is found. Check your connections and retry.
Bass Mgt - Bass Management
Indicates the selected Cross-over frequency for Bass Management.
Tools
When placing the cursor on top of a monitor, a few tools will appear:
Press this symbol to enter calibration pages
Press to mute the monitor
Press to solo the monitor