TANDBERG D12817-05 - Manual (Page 17)

TANDBERG Videoconferencing System
17
Getting started
Getting started
System start-up
Your system should be in standby mode. When in standby mode, pressing any key or picking up the remote
control will wake up the system. An incoming call will also wake up the system.
If the system does not respond, make sure the system is switched on by using the On/Off switch located at
the rear of the Codec. After a few seconds you should see the ‘Welcome’ menu on the monitor.
If this does not help, verify that your monitor is switched on. To switch the monitor on you normally push the
power button on the front of the monitor (depending on monitor type).
Welcome menu
After the system has performed a self-test routine, product logo and a ‘Welcome’ menu will be displayed on the
monitor. This menu should provide you with the most important system information. The three color-coded
commands shown correspond with the Quick keys on the remote control. This means that to make a call, you
can press the green quick-key.