TANDBERG D12817-05 - Manual (Page 26)

26
TANDBERG Videoconferencing System General use
Do Not Disturb / Sleep Mode
Press any Quick key when not in a call to activate the Quick Menu.
When Do Not Disturb is activated, the system will not accept any incoming calls. The caller will hear a busy
tone when calling this unit. A status line will indicate when Do Not Disturb is active.
mic off
Microphone on/off
To mute your microphone during a call, press M IC O FF . An on-screen indicator will appear when the
microphone is off. In a call, if audio is detected, the on-screen symbol will start to flash. Pressing M IC O FF
one more time will activate the microphone again.
General use
Adjusting volume
Press the V
OLUME
keys to adjust the volume level. An on-screen indicator will show the current level.
View outgoing video (selfview)
Press the S ELFVIEW key to view your outgoing video.
To change the image being viewed on the monitor during a call press S ELFVIEW until the desired
image is shown (far end/selfview/still image).
Press M OVE PIP to move your selfview as a Picture-in-Picture to different corners of the screen or to
switch it off.
+
-
selfview
move pip