Wireless lan settings, Tandberg videoconferencing system, Advanced use – TANDBERG D12817-05 User Manual
Page 55
TANDBERG Videoconferencing System
55
Advanced use
Wireless LAN Settings
SSID (Service Set Identification)
Example “WLANNETWORK”. Defines a local network id for this wireless region. It must be the same for all end
points and the access point. An endpoint will find the access point if the SSID is correct, however if the
encryption key is faulty it will not transmit any data.
Community (optional)
Community can be used when connecting to an access point where the SSID is the same. Example “Unit2”.
WLAN Mode
AdHoc:
Used when not communicating with an access point.
Managed:
Used when communication is made through an access point.
Restart
Make sure the corresponding settings are programmed into the access point. Press “Restart” in order to activate
the settings.
Required cards
• Compaq WL110 11 Mbps Wireless LAN
• Lucent Orinoco 11 Mbit/s SILVER
• Lucent Orinoco 11 Mbit/s GOLD
• Cisco Aironet 350 series (AIR-PCM 350 series)
• Enterasys Networks RoamAbout 802.11 DS High Rate
• Melco Buffalo WLI-PCM-L11G
Recommended access point
• Compaq WL410 base station
T
HE
PC C
ARD
/PCMCIA-
CARD
USED
MUST
COMPLY
WITH
THE
RELEVANT
REGULATIONS
FOR
SUCH
CARDS
IN
THE
COUNTRY
WHERE
IT
IS
USED
.T
HE
UNIT
MUST
BE
SUPPLIED
BY
POWER
SUPPLY
(AC-DC
ADAPTER
) P
OWER
B
OX
SPN-270-12,
WHICH
COMPLIES
WITH
THE
REQUIREMENTS
FOR
LIMITED
POWER
SOURCE
ACCORDING
TO
IEC/EN 60950
NOTE