U-Line SS1095FC - Manual (Page 12)

www.U-LineService.com 12 09/2008
SS1095
MARINE SERIES
Leveling Information
IMPORTANT
It is extremely important that the unit sits on a level
surface, as it does not have feet levelers. If it is not level,
the ice mold will not fill evenly.
Use a level to check the
levelness of the unit from
front to back and from side
to side. Level should be
placed along top edge and
side edge as shown (see
Figure 25). Go on to
9 Install the Unit.
Installation of the Unit
1. Open the water supply valve in the main water source.
2. Plug in the power cord.
3. Gently push the unit into position. Be careful not to
kink the water supply line or entangle the electrical
cord.
4. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit’s top
surface should be approximately 1/8" below the
countertop.
Grille Installation
5. Depending on your model, follow the instructions for
installing the grille (Figure 26).
SS1095NF & SS1095FC models: Place the bottom lip of
the grille on the inside of the base pan and swing grille
up into position.
SS1095FD model: Align the tabs on the bottom of the
grille with the slots in the flange and swing grille up
into position.
Align the grille and cabinet screw holes.
6. Insert the grille screw and tighten. Do not over-tighten.
7. Reconnect power to the unit.
8 Level the Unit
ULIN_1047_A
Figure 25
9 Install the Unit
ULIN_1053_A
Insert this lip behind base plate lip
Align tabs
with slots
Models
SS1095NF
& SS1095FC
Model SS1095FD
Figure 26