U-Line SS1095FC - Manual (Page 8)

www.U-LineService.com 8 09/2008
SS1095
MARINE SERIES
8. Using a Phillips screwdriver, remove the two screws
holding the custom stainless handle from the original
location, and remove the handle. Remove the two
screws on the opposite side of the door (Figure 13). Do
not place handle on door until you have completed,
steps 9 & 10.
9. Remove plastic hole plug (Figure 15) from door handle
and relocate on opposite side. Lift the handle slightly
and press on the locking tab, then gently pry the hole
plug out of the hole being careful not scratch the top
cap.
10. Relocate plastic spacer/bushing on top of door that was
underneath the hinge to the opposite hole in top cap
11. Attach handle removed in step 7 to opposite side of
door frame. Be sure to tighten all four screws removed
in step 7.
12. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 15).
13. Remove all three screws on the opposite side of the
hinge and carefully lift off the door latch assembly
(Figure 16).
ULIN_1049_A
Figure 13
Screw
ULIN_0142_A
Plastic
Plug Hole
Hinge
Plastic
Plug Hole
Right Side
Door Swing
Right
Side Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
Figure 14
ULIN_1050_A
Press in locking tab, then
lightly pry up to remove hole
plug and move to opposite
side
Figure 15
Figure 16