U-Line SS1095FC - Manual (Page 7)

09/2008 7 www.U-LineService.com
SS1095
MARINE SERIES
Reversing the Door
Depending upon the location of the unit, it may be
desirable to change the side on which the door is
mounted.
To reverse the door mounting, perform the following:
1. Remove grille (one screw) (Figure 7).
2. Remove top hinge from cabinet (three screws) (Figure
8). Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
4. Remove bottom hinge from cabinet (two screws)
(Figure 9).
5. Remove screws on opposite side of cabinet (Figure 10).
6. Install hinge on opposite side, bottom of cabinet
(Figure 11). Align hinge outer edge with cabinet
before tightening screws.
7. Relocate plastic spacer/bushing (Figure 12) on top and
bottom of door to opposite side. Clean out bushing
hole in door bottom with a screwdriver if necessary.
ULIN_1038_A
Model
SS1095FC
Model
SS1095FD
Grille
screw
Figure 7
ULIN_1044_A
Hinge screws
Figure 8
Figure 9
ULIN_0122 _A
Figure 10
Figure 11
Plastic
Spacer/Bushing
ULIN_0109_A
Figure 12