Uniden BT230 - Manual (Page 12)

12
To deactivate voice dialing, press and hold MFB until you hear a beep (about 2 seconds).
NOTE: If you are in Voice Activated Dialing mode and you activate Last Number Redial, Voice-
Activated Dialing turns off and the last number is dialed.
Use your pre-programmed voice commands as you would with your phone. (For best results, try
recording your voice tags through your headset. )
UsinG THe MULTipoinT FUnCTion
The headset supports simultaneous connection with 2 mobile phones with full control of
each one. (This feature may not be compatible with some mobile phones.)
pairing to More than one phone
Pair the headset to the first phone following the instructions on page . When you set the
headset in pairing mode and hear a high-pitched, short double-beep, pair the headset to
the second phone.
Using Both phones
The headset stays connected to both phones until a call comes in. If you answer the call, the
headset automatically disconnects from the other phone while the call is active. When you hang
up, the headset automatically reconnects to the other phone.
►
►
►