Vivotek IP3111/3121 - Manual (Page 46)

45
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097
Network settings
Any change made to this page will make the system restart to validate. Make sure every field is correctly
typed before clicking on .
To eliminate incautious mistakes during installation, Network Camera will stay in installation mode
whenever it starts unless "Reset network at next boot" is disabled. This option can also be disabled
using the Installer program. Once the option is disabled, Network Camera will skip installation at the next
boot and the Installer program will not find the installed units. That implies that Network Camera cannot
be accessed if no one remembers the IP address, except by restoring factory default settings. However,
with this option disabled Network Camera can automatically operate normally after restarting in case of
losing power. This option is ignored in the PPP connection.
Administrators may modify the network settings to fit into existing networks. Some broadband service
subnet mask may differ from the default value 255.255.255.0 and service providers may assign some