Set digital outputs, Erase logo and graphic buttons, Skip installation during the next boot – Vivotek IP3111/3121 User Manual
Page 74: Reset network for new settings, Restore factory default settings, Reset system
73
www.vivotek.com
T:
886-2-22404099
F:
886-2-22404097
Set digital outputs
To set digital output to connect NO with COMMON, type "DO=L".
To set digital output to connect NC with COMMON, type "DO=H".
Erase snapshots stored in Flash memory
Typing "erase image" will clear all snapshots saved in Flash.memory.
Erase logo and graphic buttons
Typing "erase graph" will clear all images used on the homepage. If no new images are uploaded, the
system will switch to text mode and use default images instead.
Skip installation during the next boot
Typing "lock" will inform Network Camera to fix current network settings. It need not wait for
installation during the next boot.
Reset network for new settings
Typing "unlock" will make Network Camera give up current settings and wait for installation.
Restore factory default settings
Typing "clear" will make Network Camera restore factory settings but not restart. To validate new settings,
type "reset" to make the system restart.
Reset system
Typing "reset" will make Network Camera perform a software reset.