Vivotek PZ7131 - Manual (Page 34)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
34 - User's Manual
UPnP TM component is installed on your computer�
Enable UPnP port forwarding: To access the Network Camera from the Internet, select this option to
allow the Network Camera to open ports on the router automatically so that video streams can be sent
out from a LAN� To utilize of this feature, make sure that your router supports UPnP TM and it is activated�
PPPoE (Point-to-point over Ethernet)
Select this option to configure your Network Camera to make it accessible from anywhere as long as
there is an Internet connection� Note that to utilize this feature, it requires an account provided by your
ISP�
Follow the steps below to acquire your Network Camera’s public IP address�
1� Set up the Network Camera in LAN�
2. Go to Home > Configuration > Application > Server Settings (please refer to Server Settings on page
72) to add a new server -- email or FTP server�
3. Go to Configuration > Application > Media Settings (please refer to Media Settings on page 75)� Select
System log so that you will receive a list of system log in TXT file format which contains the Network
Camera’s public IP address in your email or on the FTP server�
4. Go to Configuration > Network > Network Type. Select PPPoE and enter the user name and password
provided by your ISP� Click Save to take effect�
5� The Network Camera starts to reboot�
6� Disconnect the power source of the Network Camera; remove it from the LAN environment to the
Internet�
NOTE
► If the default ports are already used by other device connecting to the same router, the Network
Camera will select other ports for the Network Camera�
► If UPnP TM is not supported by your router, you will see the following message:
Error: Router does not support UPnP port forwarding.
► Steps to enable UPnP TM user interface on your computer:
Note that you must log on to the computer as a system administrator to install the UPnP TM
components�
Network Camera (192.168.5.151)