VistaQuest VQ-3110 - Manual (Page 12)

- 8 -
Note:
1. If the SD card is present in the camera, and then the picture/
video will save in the SD card. If no card is installed, the camera
uses internal memory.
2. If the “MEMORY FULL” warning message appears on the
LCD monitor, it means the SD card or internal memory is full.
Please remove the memory and insert a new one or move/store
all the picture/video in memory to your computer.
• Turning On the Camera:
1. Press the Power button on as shown in
the illustration.
2. Buzzer will beep and indicator lamp will
light. The LCD monitor will be turned on.
3. Press the Power button again to shut
down the camera.
• Setting the Date, Time and Date Stamp :
You should set the Date and Time when you first use your camera or the
battery is removed for an extended time (approximately 120 Seconds).
Use the following procedure to change the date and time setting.
1. Slide the Function switch to (Capture Function).
2. Press the MENU button to turn on function menu. Press ▲ or ▼
button until [Advance] option appears, and then press the Enter button
to bring up the advanced menu.
3. Use ▲ or ▼ to select [Date Time], and then press the Enter button.