Viper 5901 - Manual (Page 31)

28 © 2009 Directed Electronics. All rights reserved.
Pair Remote:
Remote Pair is a process where the Responder LC and the system in
the vehicle learn each others encrypted identification, securing their
communication from intruders. Please note that your remote controls
come pre-programmed from the factory.
Prepare the vehicle system to be Paired with a new remote
Open 1. at least one of the vehicle’s doors.
Turn 2. the key to the On position.
Within 5 seconds 3. press and release 1 time the Control button on
the Control Center.
Within 5 seconds,
4. press and hold the Control button. The status
LED will flash one time and the siren will chirp once to confirm the
system is ready for remote pairing.
Release
5. the Control button and proceed below.
Note: If pairing does not result within 60 seconds, the system will exit
and the siren will chirp.
Prepare the new remote to be Paired with the system
Make sure the remote control is set for the desired Car 1 or Car 1.
2 operation.
Perform the steps under
2. Access menu items section to access the
Pair Remote mode.
When the remote beeps 3 times and
3.
PAIR
is displayed the
remote is ready to pair.
Press
4. and hold the button, the siren will chirp once and
the remote will emit several tones to confirm successful pair-
ing.
SUCCESS
is displayed and the remote returns to the main
menu.
Note:
FAILED
will be displayed and the remote will stay in the pair
mode in case of an unsuccessful pairing. Check the system status and
try again.