Viper 5901 - Manual (Page 40)

Feature Details
37 © 2009 Directed Electronics. All rights reserved.
Note Temperature report must be turned on by an authorized Di-
rected dealer.
Remote Start Time-out Alert
During remote start a message is sent three minutes before and again
at one minute before the engine turns off. The
RUNTIME LOW
text plays
with tones as an alert to reset the runtime if desired.
Manual Transmission Start (MTS mode)
When installed into a manual transmission vehicle, the system requires
that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will not
start the engine and the
REMOTE START ERROR
text and tones play as
an alert.
With the engine running, 1. set the parking brake and leave the
engine running. For Pit Stop or Turbo Timer mode (to leave the
engine running after arming) open the driver door.
Release
2. the foot brake (if pressed during Step 1), or press and
release the foot brake anytime. As long as the engine is running
there is no time limit to perform this step.
Within 20 seconds of foot brake release,
3. press any command
button on the remote, after 20 seconds return to Step 2 (For Turbo
Timer Mode, press the optional dash mounted activation button
or send the Timer Mode command from the Advanced Start menu
screen).
The parking lights flash 5 times to confirm MTS mode enable and
4.
the remote start activates the ignition outputs. The
REMOTE START ON
text and beeps play to confirm.
Turn
5. Off and remove the key from the ignition switch, the engine
remains running.