Viper 5901 - Manual (Page 45)

42 © 2009 Directed Electronics. All rights reserved.
Out of Range
Each time a command is performed the remote will expect a com-
mand confirmation from the system. If a command confirmation is not
received the out-of-range icon (
) and a fault tone will play as an
alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command
was corrupted due to local RF interference). These are temporary nor-
mal functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.
Feature not Available
The NOT AVAILABLE message is a generic one which varies in cause
and solution depending upon the command used:
Command Cause Reason/Solution
Runtime Reset Remote Start is Off Only available when Remote Start is On
Sensor Bypass System is not armed Only available when system is armed
Defroster Remote Start is Off.
Not configured for
this. Only available when Remote Start is On.
Only available when configured for
Defroster control.