Viper 5901 - Manual (Page 47)

44 © 2009 Directed Electronics. All rights reserved.
Using the 1 way companion remote
The companion 1 way remote commands the system features as
shown in the previous table, but without the message display of the
Responder LC remote. Siren chirps and parking light flashes are used
to indicate that a command has been received and activated as de-
scribed in the Basic and Advanced command sections.
Accessing Commands
Similar to the Responder LC remote, Basic commands are performed
when a command button is pressed directly. To perform Advanced
Commands press the
button 1 to 4 times to access function lev-
els, x4 in the table for example implies pressing 4 times. The
LED flashes in groups for a few seconds to indicate the level. Press
the desired command button while the LED is flashing to perform the
command.
Button Auto Lock
When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the
button followed
by the button, the buttons unlock and tones play to confirm.
Car Select
Car 2 must first be turned On (See Remote Features menu under Pro-
gramming section below to turn on). Press and hold the button for
3 seconds. The remote flashes the LED and beeps once or twice to
indicate the selected Car is 1 or 2, release the button for Car Select
or continue to hold for programming.
Release the button, then press and release while the LED and
beeps continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.