VTech 20-2432 - Manual (Page 14)

13
Enter Base ID Code Enter Base ID Code Enter Base ID Code Enter Base ID Code Enter Base ID Code
1. After charging the Handset, remove it
from its Charge Cradle; the screen will
display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. NEW. NEW. NEW. NEW. You will now see the
ENTER BASE ID ENTER BASE ID ENTER BASE ID ENTER BASE ID ENTER BASE ID screen as described in
step 1.
4. Find the BASE ID Code BASE ID Code BASE ID Code BASE ID Code BASE ID Code by doing the
following: (the Base must be in idle (OFF)
mode)
A. At the Base
Base Base Base Base, press MENU MENU MENU MENU MENU
B. Scroll down to DISPLAY BASE-ID DISPLAY BASE-ID DISPLAY BASE-ID DISPLAY BASE-ID DISPLAY BASE-ID
C. Press OK. OK. OK. OK. OK. The Base screen will display
the 15-digit ID Code. ID Code. ID Code. ID Code. ID Code. Afterwards, it will
return the idle screen.
5. Enter the 15-digit Base ID Code Base ID Code Base ID Code Base ID Code Base ID Code into the
Handset Handset Handset Handset Handset; then press OK. OK. OK. OK. OK.
Registration and Operation Registration and Operation Registration and Operation Registration and Operation Registration and Operation
7. If the Handset displays REJECTED BY BASE REJECTED BY BASE REJECTED BY BASE REJECTED BY BASE REJECTED BY BASE or continues to display
SEARCHING FOR BASE SEARCHING FOR BASE SEARCHING FOR BASE SEARCHING FOR BASE SEARCHING FOR BASE for well beyond 60 seconds, try the registration
process again by repeating the above steps.
Congratulations! You can now enjoy the benefits of your 2-Line Multi-
Handset system.
6. Wait approximately 15 to 60 seconds. You
will hear confirmation beeps from the Base
and Handset. The newly registered Handset
will now assign itself the lowest handset
number not previously assigned to a
different system Handset (1 through 8).
Getting StartedGetting StartedGetting StartedGetting StartedGetting Started