VTech DECT CS6419-2 - Manual (Page 20)

16
Mute
The mute function allows you to hear the other party but
the other party cannot hear you.
During a call, press MUTE/
DELETE
on the handset. The
handset displays MUTED for a few seconds and MUTE
appears until the mute function is turned off.
Press
MUTE/
DELETE
again to resume the conversation.
The handset screen temporarily shows
MICROPHONE ON.
Call waiting
When you subscribe to call waiting service from your telephone service provider,
you hear an alert tone if there is an incoming call while you are on another call.
Press /FLASH to put the current call on hold and take the new call.
Press /FLASH at any time to switch back and forth between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the ringer:
When the telephone is ringing, press
OFF/
CANCEL
or MUTE/
DELETE
on the
handset, RINGER MUTED and show on the screen.
Temporary tone dialing
If you have dial pulse (rotary) dialing service only, you can temporarily switch
from dial pulse to touch-tone dialing during a call.
During a call, press
TONE
.
Use the dialing keys to enter the number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
1.
2.
•
•
1.
2.
3.
MUTED
3:15
PM
MUTE 12/25
Telephone operation