Expand your telephone system, Add and register a handset (optional), Add and register a handset – VTech DECT CS6419-2 User Manual

Page 42: Appendix

Advertising
background image

38

Expand your telephone system

The handsets provided with your telephone system are already registered. Each

handset is assigned a number that show on the handset display. Additional

handsets registered to the telephone system are assigned in sequential order.

For instance, if the telephone system already has

HANDSET 1 and

HANDSET 2, the new registered handset is assigned HANDSET 3. This

telephone system accommodates up to five handsets.

Add and register a handset (optional)

You can add new handsets (

CS6409, purchased separately) to your telephone

system. Each handset must be registered with the telephone base before use.

When first purchased, each expansion handset shows

1.PRESS FIND HS ON

BASE 4 SEC and 2.THEN PRESS # ON HANDSET alternately. You may need

to charge the handset before registering to the telephone base. For more details

on battery charging, see the table on page 4.
To register a handset:

Place the unregistered handset in the telephone base or charger. If

1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET

do not appear alternately on the handset screen after a few seconds, remove

the handset and place it in the telephone base or charger again.
On the telephone base, press and hold

/

FIND HANDSET for about four seconds until the red

IN USE light on the telephone base turns on.
On the handset, press

# (pound key) and the handset shows

REGISTERING..... PLEASE WAIT. The handset shows

HANDSET REGISTERED and you hear a beep when the

registration process completes. It takes about 60 seconds

to complete.

1.

2.

3.

Appendix

If the registration fails, the handset shows

REGISTRATION FAILED and

then

1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON

HANDSET alternately. Remove the handset from the telephone base and

place it back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
To reset the telephone, unplug the power and the battery for a few seconds

then plug them back in.
Only one handset can register to the telephone base at a time.


Advertising
This manual is related to the following products: