VTech gz5838 - Manual (Page 6)

www.vtechphones.com 6
Installation
• If you need
to install your
telephone within
the same room
as other cordless
telephones or
wireless products,
you may need to
select a different
channel for your
router or change
the channel on
your handset .
This power
adapter is
intended to be
correctly oriented
in a vertical
or floor mount
position . The
prongs are not
designed to hold
the plug in place if
it is plugged into a
ceiling, under-the-
table or cabinet
outlet
•
Telephone base installation
Install the telephone base and the power adapter as shown below . Choose a location away from
any electronic equipment and appliances such as personal computers, computer routers, wireless
routers (wireless broadband, wi-fi, or 802.11), television sets, microwave ovens and refrigerators.
Avoid excessive heat, cold, dust or moisture .
Plug the connector of the power adapter to the connector jack at the bottom of the telephone base .
Then plug the power adapter into a standard electrical outlet not controlled by a wall switch .
Connect the telephone line cord to the jack at the bottom of the telephone base, and the other
end to the wall jack .
If you receive high speed internet through your telephone line (commonly referred to as DSL) and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
•
•
To single-line
telephone jack (RJC)
Telephone line cord
DSL filter
(optional for DSL
users)
To power outlet
AC power adapter