Watlow Electric Ramping and Profiling Microprocessor-Based Control SERIES 1500 - Manual (Page 13)

Starting Out
Starting Out, Chapter 1 WATLOW Series 1500 User's Manual 13
Figure 7 -
Monitor Data
(MNTR DATA)
Mode Overview
Monitor Data Mode (MNTR DATA):
Monitoring a Halted Program
You may look at any step, but must
be in the CHG DATA mode to
change the step number.
You'll see:
• Step type.
• Ch-1 and Ch-2 set points.
• Auxiliary outputs programming.
• Step duration.
Monitoring a Running Program
You may look at the current step.
You'll see:
• Ch-1 and Ch-2 current set points.
• Auxiliaries programmed ON or OFF.
• Time remaining.
Set a Non-Ramping Set Point
Set a non-rampong (fixed)
set point and manipulate
event outputs.