Watlow Electric Ramping and Profiling Microprocessor-Based Control SERIES 1500 - Manual (Page 54)

Technical Reference
Use this chart to determine parameter ranges, limits and default settings. Then enter your setting for each
parameter. Make a photocopy of the chart and enter values for each program you use.
Program # System Programmer Date
G A Ch Pmpt Parameter Default Range
Your
. Setting
Low High Units
0000 C l UP Ch - 1 Upper Process Alarm 3200 -99 3200 ° F
1760 -99 1760 °C
C l LP Ch - 1 Lower Process Alarm -99 -99 3200 °F
-99 -99 1760 °C
C l Ud Ch - 1 Upper Deviation Alarm 3200 0 3200 °F
1760 0 1760 ° C
Cl Ld Ch - 1 Lower Deviation Alarm -999 -999 0 ° F
-999 -999 0 ° C
c 2 UP Ch - 2 Upper Process Alarm 3200 -99 3200 ° F
1760 -99 1760 ° C
C 2 LP Ch - 2 Lower Process Alarm
-99 -99 1760 °C
C2 Ud Ch - 2 Upper Deviation Alarm 3200 0 3200 ° F
1760 0 1760 °C
C2 Ld Ch - 2 Lower Deviation Alarm -999 -999 0 °F
-999 -999 0 ° C
OOOI 1H Pb Ch - 1 Prop. Band 0004 0 500 °C or F
1H RS Ch - 1 Reset 0001 0 20.00 repeats/m in.
54 WATLOW Series 1500 User’s Manual Chart 3 - Guarded Access Chart, Chapter 4
-99 -99 3200 °F
Code