Settimeout source time, Temp settings time, Tempch location time – Wegener Communications 4422 User Manual
Page 46: Unmute [source][source, A.2.12 settimeout, Source time, A.2.13 temp, Settings time, A.2.14 tempch, Location time
Page 46
UTY4422-002
Page 46 of 72
A.2.12 SETTIMEOUT
source time
source: 1 - Fade
2 - Installation
3 - Carrier Search (In the DVB-ASI mode, this means “Table Search” mode.
4 - No COMPEL
5 - Header Seek
6 - Header Search
time: Time-out value in HH:MM:SS format. Valid range is 00:00:00 to 9999:59:59.
Timeout.source is set to time.
margin_offset accordingly.
A.2.13 TEMP
settings time
settings: See Perms/Temps/Searching & Settings, Section
time: Length of insert in HH:MM:SS format. Valid range is 00:00:00 to 18:00:00.
Will handle data rate rounding as explained for PERM. Unit sets its temp_settings to settings.
See Perms/Temps/Searching & Settings, Section
(Page 35), for more information.
A.2.14 TEMPCH
location time
location: Value from 1 - 48 indicating location in settings_table.
time: Same as for TEMP.
Unit sets it temp_settings to those retrieved from the settings_table according to location.
A.2.15 UNMUTE
[source][source]
source: Same as the MUTE command.
Identical to MUTE except specified services are unmuted.