Wegener Communications 4422 - Manual (Page 50)

Page 50
UTY4422-002 Page 50 of 72
B.4.4 Aspect Ratio Settings
A S P E C T R A T I O M O D E :
x x x x
ASPECT RATIO MODE: xxxx is either 4:3, 16:9, or AUTO. Press <SELECT> to enable
changes to the aspect ratio. Press <SELECT> again to lock in the aspect ratio shown on the
LCD.
B.4.5 Audio Settings
Similar to SETAUDIO terminal command.
A U D I O S E T T I N G S :
P r e s s < S E L E C T >
Moves user to 3rd level screens under “AUDIO SETTINGS.”
Shown for each installed audio channel. One screen is shown for each channel, either 1 or 2.
P O R T # : n R O U T E : x
L A N G : y y y A T T E N : z z
PORT: n is the ASI Port number, 1 or 2.
ROUTE: x is the routing, either “S” for normal stereo, “R” for reversed stereo, “1” for original
Left to both, and “2” for original Right to both.
LANG: yyy is the character name for audio program, any set of three alphanumeric characters.
Alternately, it may be ‘*’ which is wildcard. This forces the audio program with the lowest
unselected
PID (in PMT ) associated with the selected program number (service) to be routed to
this output. Edit session begins on left-most character. Up/down arrow scrolls through all
alphanumerics as well as ‘*’.
ATTEN: zz is audio attenuation control level, and can be set between ‘0’ and ’14.’
R E T U R N :
P r e s s < S E L E C T >
Returns to 2nd level screens under “HARDWARE SETUP.”
B.4.6 Serial Ports
S E R I A L P O R T S
P r e s s < S E L E C T >
Moves user to 3rd level screens under “SERIAL PORTS.”
S E R I A L 1 : D E V I C E
S E R I A L 2 : D E V I C E
DEVICE: either PRINTER, TERMINAL, MODEM, OR AUX. DATA. See Section 3.7
(Page 34) for restrictions on DEVICE assignments.