Wegener Communications 4422 - Manual (Page 52)

Page 52
UTY4422-002 Page 52 of 72
B.4.9 Unit Reset
T O R E S E T U N I T
P r e s s < E N T E R >
Pressing <ENTER> here is analogous to cycling power. The unit is initialized without turning
off the power supply.
R E T U R N
P r e s s < S E L E C T >
Returns to Main level screens from “HARDWARE SETUP.”
B.5 STATUS REPORTS
S T A T U S R E P O R T S
P r e s s < S E L E C T >
Moves to second level screens under Status Reports.
B.5.1 Settings Status
S E T T I N G S S T A T U S
P r e s s < S E L E C T >
Moves to third level screens under Status Reports—Settings Status.
P O R T : n d d . d d d a a a a
P R O G : p p p p p h h : m m : s s
PORT: n is the ASI Port number (1 or 2).
DATA RATE (‘*” if searching): dd.ddd is the Transport Data Rate in Mbps.
MODE: aaaa is either PERM, TEMP, or SRCH. If TEMP, then hh:mm:ss is shown, which is
the time remaining in the insert.
PROGRAM # (5-digit number): ppppp is an up-to-5-digit number.
R E T U R N
P r e s s < S E L E C T >
Moves to second level screens under Status Reports.
B.5.2 ASI Input Status
A S I I N P U T S T A T U S
P r e s s < S E L E C T >
Moves to second level screens.