Wegener Communications 4422 - Manual (Page 58)

Page 58
UTY4422-002 Page 58 of 72
P r e s s < S E L E C T >
Returns to second level screen “NC Status” under “Settings Status.”
B.5.6 Parameter Status
P A R A M E T E R S T A T U S
P r e s s < S E L E C T >
Moves to third level screen under “Parameter Status.”
F A D E : 0 0 : 0 0 : 0 0
I N S T A L L : 0 0 : 0 0 : 0 0
FADE: hh:mm:ss is the time the unit will wait before going into fade mode after losing the
signal.
INSTALL: hh:mm:ss is the time the unit will stay tuned to the default signal without being
locked, before going to the search table.
S E A R C H : 0 0 : 0 0 : 0 0
N O C O M P E L : 0 0 : 0 0 : 0 0
SEARCH: hh:mm:ss: The amount of time the unit will wait for a signal to return before going
to the search table
.
NO COMPEL: hh:mm:ss Indicates how long the unit can o without seeing a valid COMPEL
signal before going to the search table.
C M P L S E E K : 0 0 : 0 0 : 0 0
H D R S R C H : 0 0 : 0 0 : 0 0
COMPEL SEEK: hh:mm:ss: The amount of time the unit can go without the proper header
before going into a search mode.
HEADER SEARCH: hh:mm:ss: The time allowed to elapse before looking for a valid header
in the COMPEL stream.
A U D D E M U X : I N S T A L L E D
A U D I O P O R T S : ( x x x x x )
AUDIO DEMUX: xxxxxxxxxx (Installed/NotInstl) This refers to Audio 2, on the Main Board.
AUDIO PORTS: This output is dependent on the Balanced Audio Card Jumper Settings.
E N C R Y P T I O N : x x x x x x x x x
ENCRYPTION: xxxxxxxxx (Installed/NotInstl)
S Y N C D A T A : x x x x x x x x x