Westell Technologies Webshare 36R566 - Manual (Page 9)

Installation/User Guide
Model # –WebShare
Part # – 030-300109 Rev C
Revision Date – 09/2000
 2000 Westell, Inc. Printed in the USA
030-300109C
8
6. The Link LED should be solid green indicating that the CPE connection has been made.
7. During use, a pulsing yellow Activity LED indicates that data is being transmitted and received on the
Ethernet interface.
8. Proceed to section 4 to configure the software.
Figure 1. WebShare Proxy Router Single User Setup Connections
3.3 Multiple User Setup
Refer to the wiring diagrams in Figure 2 and Figure 3.
1. Connect the power supply cord to the power connector on the side of the WebShare Proxy Router and
plug into a power receptacle.
2. Connect a standard RJ11 telephone cable from the LINE connector to the ADSL-equipped phone line.
3. Obtain a multi-port Ethernet Hub (available separately). Ensure that the hub includes enough Ethernet
ports to meet the requirements of the network.
4. Connect the straight 10BaseT cable (included with this package) to the jack labeled ETHERNET on the
side of the unit to the jack-designated uplink on the Ethernet Hub. With some Ethernet Hubs, a
crossover cable (available separately) may be required. Please see the documentation included with the
selected Ethernet hub.
5. Connect each additional PC to the Ethernet hub.
6. Turn the power switch ON.
LINE
ETHERNET
TO PC/LAN HUB
WEBSHARE
TO ADSL LINE
POWER
TO 117 VAC
POWER