Wire World Of America 1800 - Manual (Page 13)

7
1. Connect the provided AC power adapter from the Intelligent Gateway’s POWER port to an electrical
outlet. The green POWER light on the front of the Intelligent Gateway should light up.
2. Connect the provided Ethernet cable from any available LOCAL ETHENET port on the Intelligent
Gateway to your computer’s Ethernet port.
3. Connect the provided ADSL Filter to the telephone socket.
4. Connect the provided telephone cable from the PHONE LINE port on the Intelligent Gateway to the
ADSL MODEM socket on the ADSL Filter.
This connects the internal DSL modem of the Intelligent Gateway to your DSL service provider. If you
have been using an external DSL modem, disconnect it as you will no longer need it.
5. (Optional). If you had a telephone connected to the telephone socket, you can reconnect it to the
PHONE port on the ADSL Filter.
Check your connections
Power-on your computer. When your computer is fully powered-up, verify the POWER and LOCAL
NETWORK indicator lights on the front of the Intelligent Gateway are green. If they are not, see
“Diagnosing connection problems” on page 110. The BROADBAND LINK indicator light will not turn green
until the Intelligent Gateway software has been installed and an Internet connection has been established.
Continue from here to Step 3 “Install the Intelligent Gateway Software” on page 12.
Ethernet Connection
Requires a computer with an Ethernet port